Skip to the beginning of the images gallery

Wencon Rotating Blaster

Product ID

Wencon Rotating Blaster disc for removal of rust, dirt, paint and epoxy from materials, such as; steel, iron, metal, stone and concrete.

Excellent surface preparation
Needle hammering with electric drill
Best alternative to blasting
Easy to use
Long durability / service life

Wencon Rotating Blaster discs are available as Single, Duo and Triss discs for handdrilling machines. The Single disc is for use at small surfaces and in corners. Duo and Triss discs are for use at bigger surfaces.

Key technical data

No. 1252	Wencon Rotating Blaster Duo
No. 1254	Wencon Rotating Blaster Triss

Wencon Rotating Blaster

Wencon Rotating Blaster is a rotating disc for removal of rust, dirt, paint, epoxy etc. from various materials, such as steel, iron, metals, stone and concrete.

Wencon Rotating Blaster is a rubber disc with 12 steel pins vulcanised inside, with an axle in the middle, for use in a hand drilling machine. The steel pins are made of special hard metal, mounted with conical shape. The disc is made of 96% natural rubber and is therefore very flexible. When the disc is rotating the pins are moving in different directions and the pins will hammer directly on the surface.

In situations where shot blasting is not possible, the Rotating Blaster is an alternative method for surface preparation. The blaster will leave the treated surface with a texture suitable for the application of a new protective coating. The hammer effect creates no heat, so tough materials such as tar, adhesives and sealants will be easily removed.

PACKAGING

Wencon Rotating Blaster discs are available as Duo and Triss discs for hand drilling machines.

GENERAL DESCRIPTION

Rotating Blaster disc for removal of rust, dirt, paint and epoxy from materials, such as; steel, iron, metal, stone and concrete.

SIZE

Disc Diameter : 126 mm + / - 0.8mm
Disc Thickness : 6.7 mm + / - 0.3mm
Stud Record : 8 mm

MATERIAL

Rubber : Natural rubber with binder and 50 Shore A hardness.

Tungsted : Carbide/Hard Metal: Hardness 1500HV

USE AND SAFETY

ALWAYS wear safety goggles, working gloves, dust mask and protective clothing
Maximum speed 4000 rpm
Recommended speed between 2500 and 3000 rpm; DIRECTION = clockwise. At a lower rpm the effect will be less, but the disc will then become more flexible and gives the opportunity to reach difficult places like corners. In this situation 1200 rpm is recommended.
Disc should never be used on: edges, raised surfaces etc.